· Double balance is performed at the four corners of the machine using 4 guide posts and dual flexible arms so that the balance
is accurate and the pressure in the middle of the working table is the same as that of the edges.
· All sliding parts are lubricated with oils supplied by the hydraulic system so that service life of the machine is prolonged.
· External oil pump, motor and electrical box allow for ventilating and cooling conditions as well as prolonged service life.
· In the absence of heat source, the hydraulic oil is of low temperature and never deteriorates, therefore extending the service
life of the sealing element.
|
|
XCLP 2 SERIES HYDRAULIC PLANE CUTTING MACHINE THAT WE WILL ELIMINATE SOON
|
Due to short, small and few balance points, there is wide pressure differences between the center, the edges and two sides of
the working table, leading to the situation whereby the center is cut while other parts are not when cutting.
· Due to lack of adequate lubrication and few balance locations, abnormal wear may develop on single side of the balance post
and can not be repaired.
· The bar and the beam are usually stretched broken at the center of the their two ends during the use of the machine.
· Fully built-in electrical and hydraulic systems lead to excessively high oil temperature, aging sealing element, and deterioration of
hydraulic oil as well as reduced mechanical pressure.